ETi-300 / ETi-350

Key advantages

• A comprehensive end-to-end tube inspection solution.
• Up to 15 hours battery life.
• Constant 16kHz sample rate across all channels.
• High impact resistant aluminium enclosure designed to meet IP66.
• ETherMap intuitive interface for tube inspection data capture and analysis.
• TMR Tube Mapping software – map from schematics or photographs.
• TMR Automated Reporting software – easy to use and customisable.
• ETi-350 delivers the ETi-300 and laptop housed in a site-rugged Peli 1550 case.
• 2 year warranty, extendable to 5 years with ETherCover.

Overview

The ETi-300 is an advanced eddy current instrument for inspecting non-ferrous tubing from the inner diameter (ID). Eddy current is the usual method for checking the many tubes in a heat exchanger quickly. The ETi-300 and its software are used for heat exchanger and condenser inspection in power generation, transportation, petrochemical and oil and gas.

Performance

• Wide 10Hz – 12.8MHz test frequency range for any material or wall thickness.
• Clear, low-noise signals, including at low test frequencies.
• Fully configurable automatic mixing for an optimum setup.
• 16,000 samples per second over all channels for very high probe pull-back speeds.
• Digital data transfer over full speed USB 2.0.
• 15 hours battery life with 2.5 hour charge (1 hour gives 6 more hours).

Built for site

Sealed, fanless and rated to IP66, the ETi-300 resists dust and water ingress. A heavy-duty cast and extruded aluminium enclosure with silicone corner protectors survives knocks and drops, yet weighs just 2.8kg (214 x 90 x 342mm).

Software suite

• TMR Mapping – create tube map templates for inspection planning from photographs, drawings or manual entry.
• ETherMap – the user interface for the headless instrument; controls live inspections, displays strip charts and phase plane, and builds calibration curves to estimate defect size and type.
• TMR Reporting – turns analysed data into inspection reports.